When apologizing hurts: Felt transgression and restoration efforts

Apologizing is important for conflict resolution and relationship reconciliation, yet apologies often fail to restore the damaged relationship. While much research has been devoted to investigating the victims' reactions upon receiving an apology, in this paper, we adopt an apologizer-centric approach and explore the phenomenon of apologizing with no felt transgression (vis-à-vis when there is felt transgression) along with its affective and reconciliation outcomes for the apologizer. Based on Appraisal Tendency Framework, we predict that apologizing with no felt transgression will lead to reduced guilt and increased anger in the apologizer, which will result in a decreased level of their restoration efforts towards the victim. In addition, we further hypothesize about the role of organizational conflict cultures in influencing the relationship between apologizing and restoration efforts via guilt and anger. Study 1 uses a micro-narrative procedure and an inductive data analysis approach to demonstrate the varied situations and motivations of employees apologizing with (no) felt transgression, Study 2 utilizes an experimental design to examine the mediation effect, and Study 3 employs the critical incident technique to test our whole research model. Our hypotheses were largely supported across our studies. Theoretical and practical implications are discussed.     

Material hygiene: improving recycling of WEEE demonstrated on dishwashers

There must be a change in attitude towards end-of-life products. The view that these products pose a liability must be changed. Secondary material is valuable as raw material. Thus, activities encouraging changes in opinion are important.Two major EU directives guide the recycling process; the Directive of End-of-Life Vehicles (ELV) and the Directive of Waste Electrical and Electronic Equipment (WEEE). Both focus on the input of the recycling system, not on what is coming out of the system.The WEEE Directive is the legislation on the European level that governs the handling and processing of these types of products. The WEEE Directive is not only aimed at stricter handling and reduction of hazardous materials but also encourages EU member states to support technical development in order to facilitate increased recycling.In order to properly address these issues a mind-set, material hygiene, has been introduced. The basic idea is to act, in every life cycle phase of the product, towards highest possible efficiency in recycling. The outcome of useful material is in focus.A study on dishwashers is made with copper outcome as target. The results are based on Swedish conditions but general conclusions can be made. Limited design efforts can raise the outcome of valuable materials, if the recycling process is organized in an optimal manner.A theoretical concept of disassembly structures is used to draw general conclusions on the case study.Increasing product recycling suitability is one side of the problem; another is increasing effectiveness of handling and processing of end-of-life products.The purpose of this paper is to introduce the concept of “material hygiene” and based on that demonstrate a method for grading structural properties in a recycling perspective. The findings presented in this paper are based on a field study in which a number of dishwashers were disassembled and analyzed.     

Farm factors associated with reducing Cryptosporidium loading in storm runoff from dairies

A systems approach was used to evaluate environmental loading of Cryptosporidium oocysts on five coastal dairies in California. One aspect of the study was to determine Cryptosporidium oocyst concentrations and loads for 350 storm runoff samples from dairy high use areas collected over two storm seasons. Selected farm factors and beneficial management practices (BMPs) associated with reducing the Cryptosporidium load in storm runoff were assessed. Using immunomagnetic separation (IMS) with direct fluorescent antibody (DFA) analysis, Cryptosporidium oocysts were detected on four of the five farms and in 21% of storm runoff samples overall. Oocysts were detected in 59% of runoff samples collected near cattle less than 2 mo old, while 10% of runoff samples collected near cattle over 6 mo old were positive. Factors associated with environmental loading of Cryptosporidium oocysts included cattle age class, 24 h precipitation, and cumulative seasonal precipitation, but not percent slope, lot acreage, cattle stocking number, or cattle density. Vegetated buffer strips and straw mulch application significantly reduced the protozoal concentrations and loads in storm runoff, while cattle exclusion and removal of manure did not. The study findings suggest that BMPs such as vegetated buffer strips and straw mulch application, especially when placed near calf areas, will reduce environmental loading of fecal protozoa and improve stormwater quality. These findings are assisting working dairies in their efforts to improve farm and ecosystem health along the California coast.     

EVALUATION OF AN INDUCED INFILTRATION MODEL AS APPLIED TO GLACIAL AQUIFER SYSTEMS1

ABSTRACT: Numerical models were used to examine the limitations of the assumptions used in an analytical induced infiltration model. The assumptions tested included negligible streambed effects, negligible areal recharge, two-dimensional ground water flow, fully penetrating rivers and wells, and constant surface water stage. For situations that deviate from the underlying assumptions, the analytical model becomes a less reliable predictor of induced infiltration. The numerical experiments show that streambed effects cannot be neglected if the streambed conductivity is more than one order of magnitude lower than the aquifer hydraulic conductivity. Areal recharge cannot be neglected if the ground water basin receives more than 5 in/yr of areal recharge. Three-dimensional flow effects due to well partial penetration cannot be neglected if the ratio of horizontal hydraulic conductivity to vertical hydraulic conductivity (K_h/K_u) is greater than 10. Surface water elevation fluctuations can significantly influence the induced infiltration rate, depending on the degree of fluctuations and the ground water hydraulic gradient.     

Associations between grab sample and integrated radon measurements in dwellings in Maine and Texas

Radon concentrations were measured in several locations in each of approximately 100 dwellings in central Maine and in Houston, TX. Integrated samples were taken during the heating (or cooling) seasons with commercially available passive alpha track devices, while grab samples were taken at the time of integrated sampler deployment. It was found that both indoor and outdoor measurements in both areas were distributed log normally, and that the geometric mean of indoor measurements in Maine was three times higher than that of corresponding measurements in the Houston area. It was also noted that the mean of the indoor grab sample measurements was not significantly different from the mean of the indoor integrated measurements, and that the degree of correlation between the grab samples and a given indoor integrated sample was nearly as good as between integrated samples taken at different living area locations.     

Cell-cell recognition system in gorgonians: description of the basic mechanism

A comparative investigation of the chemical composition of Thalassiosira antarctica var. antarctica vegetative and resting stages revealed C:N and C:chl a ratios to be lower in vegetative cells. These trends primarily reflect vegetative levels of C/cell below, and N/cell and chl a/cell levels above those of spores. There was a change in chemical composition with the initial formation of resting spores, and spores continued to modify their composition while maintained in a cyclic light/dark regime for about one and one half weeks. Most notable was a net increase in carbon and chlorophyll a per cell. Spores then subjected to darkness for over one week appeared to retain most of the carbon and chlorophyll a previously synthesized. These findings support the idea that resting spores enhance the survival capabilities of a species under adverse conditions.     

Pyrene bioavailability; effect of sediment-chemical contact time on routes of uptake in an oligochaete worm

Bioavailability of sediment-sorbed compounds may vary with increasing contact time. This may result in the dietary uptake route becoming more significant as conditions in the gut flora aid the extraction of contaminants, which have migrated into sites within the sediment particle. Such mechanisms may have important implications on risk assessments performed on substances released into the environment. A series of experiments were carried out using sediment spiked with 14C-labelled pyrene, a polycyclic aromatic hydrocarbon. The sediment was left at room temperature over a period of 220 days. Periodically (at 0, 1, 14, 28, 70, 220 days) the sediment was used to perform a bioaccumulation study using the freshwater oligochaete Lumbriculus variegatus. A novel methodology using feeding and (decapitated) non-feeding worms, allowed differentiation between uptake via ingestion and simple sorption. Results showed that there was a decline in bioavailability with time and that this was a 3 stage process. A rapid initial decline was observed over the first day when a 40% decrease was measured, an intermediate period were levels remained stable (day 14 to day 70) and an ultimate decrease in pyrene activity in worm tissue of 70% after 220 days. Over this period the chemical extractability of pyrene also decreased by 50%, as the chemical migrated deeper into unavailable sites within the sediment matrix. Normalising bioavailability to the chemically extractable fraction of pyrene within the sediment provided an overall decrease in bioavailability of 58%. The importance of the dietary route of uptake for pyrene varied during the sediment aging process, reflecting the changes in the physico-chemical interactions between the pyrene, sediment and pore water.     

HYSTAR Sediment Model: Distributed Two‐Dimensional Simulation of Watershed Erosion and Sediment Transport Using Time‐Area Routing

An erosion and sediment transport component incorporated in the HYdrology Simulation using Time‐ARea method (HYSTAR) upland watershed model provides grid‐based prediction of erosion, transport and deposition of sediment in a dynamic, continuous, and fully distributed framework. The model represents the spatiotemporally varied flow in sediment transport simulation by coupling the time‐area routing method and sediment transport capacity approach within a grid‐based spatial data model. This avoids the common, and simplistic, approach of using the Universal Soil Loss Equation (USLE) to estimate erosion rates with a delivery ratio to relate gross soil erosion to sediment yield of a watershed, while enabling us to simulate two‐dimensional sediment transport processes without the complexity of numerical solution of the partial differential governing equations. In using the time‐area method for routing sediment, the model offers a novel alternative to watershed‐scale sediment transport simulation that provides detailed spatial representation. In predicting four‐year sediment hydrographs of a watershed in Virginia, the model provided good performance with R² of 0.82 and 0.78 and relative error of ?35% and 11% using the Yalin and Yang's sediment transport capacity equations, respectively. Prediction of spatiotemporal variation in sediment transport processes was evaluated using maps of sediment transport rates, concentrations, and erosion and deposition mass, which compare well with expected behavior of flow hydraulics and sediment transport processes.